Thermal Cure: Difference between revisions
Jump to navigation
Jump to search
Content deleted Content added
linked UV curing page for initial tack |
updated recipes table |
||
| (One intermediate revision by the same user not shown) | |||
| Line 21: | Line 21: | ||
|120°C/30min |
|120°C/30min |
||
|100°C/1 hour |
|100°C/1 hour |
||
|175°C/1min |
|||
| ⚫ | |||
| |
| |
||
|- |
|- |
||
| Line 58: | Line 58: | ||
| |
| |
||
|1500mW/cm2 for 30 sec |
|1500mW/cm2 for 30 sec |
||
|- |
|||
|UNIMEC H9890-6A |
|||
|Ramp up 60 min. to 175°C + 90 min. hold @ 175°C |
|||
| ⚫ | |||
| |
|||
| |
|||
| |
|||
|} |
|} |
||
* Curing UNIMEC H9890-6A at lower temperatures may result in lower thermal conductivity |
|||
Latest revision as of 07:57, 21 September 2026
Bake Recipes
The following are recommended cure times and temperatures based on manufacturer's technical data sheet information. For hybrid materials, do UV initial tack before thermal bake for full crosslink.
| Material | Recommended Cure (Temp°C/Time) | Alternate 1 | Alternate 2 | Alternate 3 | Initial Tack |
|---|---|---|---|---|---|
| HYB-353ND | 100°C/30 min | 150°C/30 min | 80°C/ 1 hour | 100mW/cm2 for 1min | |
| H70E | 150°C/1 hour | 120°C/30min | 100°C/1 hour | 175°C/1min | |
| H20E | 150°C/1 hour | 80°C/3 hours | |||
| GA700H | 100°C/1 hour | 150mW/cm2 for 2 min | |||
| 3553-LV-UTF_HM | 110°C/1 hour | 1000mW/cm2 for 30 sec | |||
| CHIPSHIELD 2401 | 110°C/1 hour | 1000mW/cm2 for 30 sec | |||
| OPTOCAST 3410 | 110°C/1 hour | 1500mW/cm2 for 30 sec | |||
| UNIMEC H9890-6A | Ramp up 60 min. to 175°C + 90 min. hold @ 175°C |
- Curing UNIMEC H9890-6A at lower temperatures may result in lower thermal conductivity